Ampera

Blog · 9 November 2026

How to read a KNX wiring diagram without being an integrator

Bus, power and loads: what the lines and colours in an Ampera piece sheet mean, and what stays with the electrician.

A wiring diagram in an Ampera piece sheet shows three things, in three kinds of lines.

The bus

The KNX bus is a pair of wires that carries commands, not power for the lamp. In the diagrams it is the red and black pair of the KNX cable (red/black = bus). Devices are connected to it in parallel; each device gets its address later, in ETS.

The mains

Phase, neutral and earth go to the loads and to the actuator’s power terminals, never to the bus terminals. In the diagrams the phase is brown, the neutral blue and the earth green-yellow, as a reminder: always follow the colours of the local standard and the product sheet.

The load

The actuator closes or opens the load circuit: a lamp, a shutter motor. A dimming actuator needs a dimmable driver; that is why the sheet reminds you to check compatibility.

What Ampera does not do

Ampera prepares the data for ETS (addresses, CSV, order of work) and does not programme devices. The diagrams are didactic and must be confirmed with the product sheet; connection to the panel and commissioning belong to an authorised electrician.

Open the demo ← All articles